Infra-View® Infrared Boiler/Furnace Thermometers
Natural Gas Applications

Natural Gas Fired
Infrared Boiler / Furnace Thermometer

250°F (120°C) to 3,000°F (1,650°C)


Infra-View® NATGAS Infrared Boiler / Furnace Thermometer is a "non-contact" remote sensing infrared thermometer housed in a compact protective cooling jacket specially designed for clean burning natural gas fired boilers and furnaces.

Specifically designed for natural gas fired boilers, this Infra-View model is cost effective, while providing the accuracy and efficacy found in our Infra-View Boiler Thermometer normally used on coal, oil and WTE boilers.

The stream lined cooling jacket enables fit into tight areas while providing protection, cooling and air purge for the Infra-View loop powered sensor. The Infra-View sensor is a 24 VDC loop powered device that provides a 4 – 20 mA output to any DCS, digital or analog recording device.

The unit flange mounts to any port, door or penetration into the boiler or furnace and measures flue gas temperatures from 250° F to 3,000° F.

(NATGAS) Technical Specification

Infra-View® NATGAS Infrared Boiler / Furnace Thermometer is a "non-contact" remote sensing infrared thermometer housed in a compact protective cooling jacket specially designed for clean burning natural gas fired boilers and furnaces. The unit flange mounts to any port, door or penetration into the boiler or furnace and measures flue gas temperatures from 250°F to 3,000°F via a 4 – 20 mA output to any DCS, digital or analog recording device.

  • Power Requirement: 24 VDC 4 - 20 mA integrated loop powered
  • Cooling Requirement: 5 – 10 SCFM (Instrument Air or clean filtered plant air)
  • Ambient Operating Temp: 200°F Max.
  • Field of View (FOV): 30:1 (i.e., 3 ft spot @ 90 ft)
  • Response Time: 100 msec (600 readings/min.)
  • Data Output: Digital 4-20 mA Loop Powered
  • Accuracy: 1% of Reading (Max. Error + 30°F) NIST Calibration Cert. Avail.
  • Measured Temperature Range: 250°F to 3,000°F
  • Infrared Spectral Response: Heated CO2 Gas
  • Weight: 10 lbs (4.5 Kg)
  • Length Overall: 16" (51 cm)
  • Infra-View® Basic Sensor: 2 wire 4 – 20 mA loop powered digital device
  • Signal Output: 10 sec. pre-set averaging
  • Flange Conn: 2"Ø 125 # flange

 

 


85 Industrial Ave. * Little Ferry, NJ  07643 U.S.A.
Phone: 1.201.641.2131 * Fax: 1.201.641.2309

web design by JNT Technical Services, Inc.